STARTMODE=auto
#IPADDR=192.168.1.7
NETMASK=255.255.255.0
INTERFACETYPE="wireless"
USERCONTROL=yes
NAME="WlanKarte"
NM_CONTROLLED=no
WIRELESS='yes'
WIRELESS_MODE='managed'
WIRELESS_ESSID='xxxx'
WIRELESS_AUTH_MODE='psk'
WIRELESS_WPA_PSK='xxxx'
WIRELESS_CIPHER_PAIRWISE='TKIP'
WIRELESS_CIPHER_GROUP='TKIP'
BOOTPROTO='dhcp'

## Type:	list(0,1,2)
## Default:	1
#
# Defines which SSID scan mode should be used. Mode 0 means the driver
# performs the scan. Mode 1 means wpa_supplicant takes care of scanning.  Mode
# 2 is basically the same as mode 0 but the access point gets chosen by
# security policy and SSID. This mode does not support multiple network
# settings. Default is "1" for most drivers. Try "0" or "2" if you have
# problems associating to your access point. This variable can have no
# suffix. This is only used in conjuntion with wpa_supplicant.
WIRELESS_AP_SCANMODE='1'

## Type:	string
## Default:	""
#
# If have configured a WPA mode in WIRELESS_AUTH_MODE you can use this
# variable to supply a custom wpa_supplicant.conf that will be used instead of
# the one ifup would generate. The file has to be specified with full path. Of
# course you can setup any configuration suitable for wpa_supplicant with
# this, not only WPA modes. This variable can have no suffix. If you want to
# have multiple network support, you need to create a wpa_supplicant.conf with
# mulitle network sections (see wpa_supplicant documentation).
WIRELESS_WPA_CONF='/etc/wpa_supplicant/wpa_supplicant.conf'


## Type:	string
## Default:	""
#
# In environments with multiple Access points you may want to define the one
# to connect to by entering its MAC address. Format is 6x2 hex digits,
# seperated by colons, eg 01:02:03:04:05:06.
# See also the iwconfig ap option description in the iwconfig(8) manual page.
#
# Note, that some drivers (mac80211 based) may require to set this variable
# to a specific access point address, 'any' or 'off' to start scanning for
# an appropriate cell, so ifup-wireless sets it to 'any' in Managed and
# Ad-Hoc modes when the variable is empty.
#WIRELESS_AP="xxxx"