Feb 25 19:35:47 linux-y1p2 kernel: [  232.112412] usb 1-1.4: new high-speed USB device number 5 using ehci_hcd
Feb 25 19:35:47 linux-y1p2 kernel: [  232.199338] usb 1-1.4: New USB device found, idVendor=0bda, idProduct=8178
Feb 25 19:35:47 linux-y1p2 kernel: [  232.199343] usb 1-1.4: New USB device strings: Mfr=1, Product=2, SerialNumber=3
Feb 25 19:35:47 linux-y1p2 kernel: [  232.199346] usb 1-1.4: Product: 802.11n WLAN Adapter
Feb 25 19:35:47 linux-y1p2 kernel: [  232.199348] usb 1-1.4: Manufacturer: Realtek
Feb 25 19:35:47 linux-y1p2 kernel: [  232.199350] usb 1-1.4: SerialNumber: 00e04c000001
Feb 25 19:35:47 linux-y1p2 mtp-probe: checking bus 1, device 5: "/sys/devices/pci0000:00/0000:00:1a.0/usb1/1-1/1-1.4"
Feb 25 19:35:47 linux-y1p2 mtp-probe: bus: 1, device: 5 was not an MTP device
Feb 25 19:35:47 linux-y1p2 kernel: [  232.238110] cfg80211: Calling CRDA to update world regulatory domain
Feb 25 19:35:47 linux-y1p2 kernel: [  232.280390] cfg80211: World regulatory domain updated:
Feb 25 19:35:47 linux-y1p2 kernel: [  232.280391] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
Feb 25 19:35:47 linux-y1p2 kernel: [  232.280393] cfg80211:   (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
Feb 25 19:35:47 linux-y1p2 kernel: [  232.280394] cfg80211:   (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
Feb 25 19:35:47 linux-y1p2 kernel: [  232.280395] cfg80211:   (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
Feb 25 19:35:47 linux-y1p2 kernel: [  232.280396] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
Feb 25 19:35:47 linux-y1p2 kernel: [  232.280397] cfg80211:   (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
Feb 25 19:35:47 linux-y1p2 kernel: [  232.308322] rtl8192cu: Chip version 0x11
Feb 25 19:35:47 linux-y1p2 kernel: [  232.384939] rtl8192cu: MAC address: 00:1f:cf:52:cb:55
Feb 25 19:35:47 linux-y1p2 kernel: [  232.384945] rtl8192cu: Board Type 0
Feb 25 19:35:47 linux-y1p2 kernel: [  232.385339] rtlwifi: rx_max_size 15360, rx_urb_num 8, in_ep 1
Feb 25 19:35:47 linux-y1p2 kernel: [  232.385372] rtl8192cu: Loading firmware rtlwifi/rtl8192cufw.bin
Feb 25 19:35:47 linux-y1p2 kernel: [  232.385437] usbcore: registered new interface driver rtl8192cu
Feb 25 19:35:48 linux-y1p2 kernel: [  232.440097] ieee80211 phy0: Selected rate control algorithm 'rtl_rc'
Feb 25 19:35:48 linux-y1p2 kernel: [  232.440562] rtlwifi: wireless switch is on
Feb 25 19:35:48 linux-y1p2 ifup[1844]: Service network not started and mode 'auto' -> skipping
Feb 25 19:35:48 linux-y1p2 kernel: [  232.546603] rtl8192cu: MAC auto ON okay!
Feb 25 19:35:48 linux-y1p2 kernel: [  232.579207] rtl8192cu: Tx queue select: 0x05
Feb 25 19:35:48 linux-y1p2 kernel: [  232.951622] ADDRCONF(NETDEV_UP): wlan0: link is not ready                                            
Feb 25 19:35:48 linux-y1p2 dbus-daemon[685]: dbus[685]: [system] Activating service name='fi.w1.wpa_supplicant1' (using servicehelper)     
Feb 25 19:35:48 linux-y1p2 dbus[685]: [system] Activating service name='fi.w1.wpa_supplicant1' (using servicehelper)                       
Feb 25 19:35:48 linux-y1p2 dbus-daemon[685]: dbus[685]: [system] Successfully activated service 'fi.w1.wpa_supplicant1'                    
Feb 25 19:35:48 linux-y1p2 dbus[685]: [system] Successfully activated service 'fi.w1.wpa_supplicant1'