william@linux-vcgv:~> su
Passwort: 
linux-vcgv:/home/william # date
Fr 22. Jan 20:27:40 CET 2010
linux-vcgv:/home/william # lsmod | grep rtl8187
linux-vcgv:/home/william # hwinfo --netcard
27: PCI 108.0: 0200 Ethernet controller                         
  [Created at pci.318]
  UDI: /org/freedesktop/Hal/devices/pci_10ec_8139
  Unique ID: rBUF.t9HZFUJPe8E
  Parent ID: 8otl.Ao4TF0pWC38
  SysFS ID: /devices/pci0000:00/0000:00:04.0/0000:01:08.0
  SysFS BusID: 0000:01:08.0
  Hardware Class: network
  Model: "Realtek RTL-8139/8139C/8139C+"
  Vendor: pci 0x10ec "Realtek Semiconductor Co., Ltd."
  Device: pci 0x8139 "RTL-8139/8139C/8139C+"
  SubVendor: pci 0x147b "ABIT Computer Corp."
  SubDevice: pci 0x1c38 
  Revision: 0x10
  Driver: "8139too"
  Driver Modules: "8139too"
  Device File: eth0
  I/O Ports: 0xcc00-0xccff (rw)
  Memory Range: 0xfdfff000-0xfdfff0ff (rw,non-prefetchable)
  IRQ: 18 (no events)
  HW Address: 00:18:37:01:ac:a3
  Link detected: no
  Module Alias: "pci:v000010ECd00008139sv0000147Bsd00001C38bc02sc00i00"
  Driver Info #0:
    Driver Status: 8139too is active
    Driver Activation Cmd: "modprobe 8139too"
  Driver Info #1:
    Driver Status: 8139cp is active
    Driver Activation Cmd: "modprobe 8139cp"
  Driver Info #2:
    Driver Status: epl is active
    Driver Activation Cmd: "modprobe epl"
  Config Status: cfg=no, avail=yes, need=no, active=unknown
  Attached to: #16 (PCI bridge)

46: USB 00.0: 0282 WLAN controller
  [Created at usb.122]
  UDI: /org/freedesktop/Hal/devices/usb_device_50d_705c_noserial_if0
  Unique ID: Uc5H.GfMvZg9JY12
  Parent ID: k4bc.OqydEZZ981A
  SysFS ID: /devices/pci0000:00/0000:00:02.1/usb1/1-4/1-4:1.0
  SysFS BusID: 1-4:1.0
  Hardware Class: network
  Model: "Belkin USB2.0 WLAN"
  Hotplug: USB
  Vendor: usb 0x050d "Belkin Components"
  Device: usb 0x705c "USB2.0 WLAN"
  Revision: "48.10"
  Driver: "zd1211rw"
  Driver Modules: "zd1211rw"
  Device File: wlan0
  Features: WLAN
  Speed: 480 Mbps
  HW Address: 00:22:75:75:c1:8b
  Link detected: yes
  WLAN channels: 1 2 3 4 5 6 7 8 9 10 11 12 13 14
  WLAN frequencies: 2.412 2.417 2.422 2.427 2.432 2.437 2.442 2.447 2.452 2.457 2.462 2.467 2.472 2.484
  WLAN encryption modes: WEP40 WEP104 TKIP CCMP
  WLAN authentication modes: open sharedkey wpa-psk wpa-eap
  Module Alias: "usb:v050Dp705Cd4810dcFFdscFFdpFFicFFisc00ip00"
  Driver Info #0:
    Driver Status: zd1211rw is active
    Driver Activation Cmd: "modprobe zd1211rw"
  Config Status: cfg=no, avail=yes, need=no, active=unknown
  Attached to: #44 (Hub)
linux-vcgv:/home/william # iwconfig
lo        no wireless extensions.

eth0      no wireless extensions.

wmaster0  no wireless extensions.

wlan0     IEEE 802.11bg  ESSID:"FRITZ!Box WLAN 3131"  
          Mode:Managed  Frequency:2.412 GHz  Access Point: 00:1C:4A:06:B7:0C   
          Bit Rate=1 Mb/s   Tx-Power=20 dBm   
          Retry  long limit:7   RTS thr:off   Fragment thr:off
          Encryption key:2E35-308F-5FD5-4C51-549E-27B6-ED09-84A8-66C8-B660-8741-F4FF-B11A-1337-765B-0625 [3]
          Power Management:off
          Link Quality=37/100  Signal level=37/100  
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

linux-vcgv:/home/william # cd Downloads
linux-vcgv:/home/william/Downloads # ./collectNWData.sh
collectNWData.sh V0.6.1.26 (Rev: 1.186, Build: 2009/12/13 18:42:45 UTC)

--- Welcher Netzwerkverbindungtyp soll getestet werden?
--- (1) Kabelgebundene Verbindung
--- (2) Kabellose Verbindung (WLAN)
--- Bitte mit 1-2 anworten:2

--- Welche Netzwerktopologie liegt vor?
--- (1) WLAN access point <---> LinuxClient
--- (2) WLAN HW router <---> LinuxClient
--- (3) WLAN access point <---> LinuxRouter <---> LinuxClient
--- (4) WLAN HW router <---> LinuxRouter <---> LinuxClient
--- Bitte mit 1-4 anworten:2

--- NWEliza untersucht das System nach haeufigen Netzwerkkonfigurationsfehlern untersucht ...
!!! CND0230W: IPV6 ist eingeschaltet
!!! CND0240E: Knetworkmanager wird fuer die Netzwerkkonfiguration benutzt aber eine YAST Netzwerkkartenkonfiguration f�r eth0 existiert

--- NWCollect sammelt Netzwerkkonfigurationsinformationen in Datei collectNWData.txt ...
            
--- Gehe zu http://www.linux-tips-and-tricks.de/CND um detailiertere Hinweise zu den Fehlermeldungen/Warnungen zu bekommen und wie die Fehler selbst beseitigt werden koennen

linux-vcgv:/home/william/Downloads #