Hallo,
ich hab' ein kleines Problem mit meinem Notebook.
Ich sitze hier im Büro, wähle das WLAN aus mit dem ich mich verbinden möchte, gebe das Passwort ein und die Verbindung wird hergestellt.
So weit - so gut.
Bricht die Verbindung ab, versucht er sich automatisch neu zu verbinden. Leider kommt dabei keine Verbindung mehr zustande. Er wartet auf Authentifizierung... Und wartet...
Ich muß also im NetworkManager die Verbindung löschen und neu einrichten. Dabei muß ich immer das wahnsinnig lange Passwort eingeben - und das nervt.
Kann mir jemand helfen das Problem zu lösen?
Gruß,
Rob
Ich nutze OpenSUSE 12.3 x86_64 mit KDE 4.10.5
Code
37: PCI 4300.0: 0282 WLAN controller
[Created at pci.319]
Unique ID: y9sn.YXxFBNiV6c8
Parent ID: Z7uZ.Pgi_q4KD0y3
SysFS ID: /devices/pci0000:00/0000:00:1c.3/0000:43:00.0
SysFS BusID: 0000:43:00.0
Hardware Class: network
Model: "Broadcom BCM4312 802.11b/g"
Vendor: pci 0x14e4 "Broadcom"
Device: pci 0x4315 "BCM4312 802.11b/g"
SubVendor: pci 0x103c "Hewlett-Packard Company"
SubDevice: pci 0x1508
Revision: 0x01
Driver: "b43-pci-bridge"
Driver Modules: "ssb"
Device File: wlan0
Features: WLAN
Memory Range: 0xd0500000-0xd0503fff (rw,non-prefetchable)
IRQ: 19 (176533 events)
HW Address: c0:cb:38:8b:83:59
Link detected: yes
WLAN channels: 1 2 3 4 5 6 7 8 9 10 11 12 13 14
WLAN frequencies: 2.412 2.417 2.422 2.427 2.432 2.437 2.442 2.447 2.452 2.457 2.462 2.467 2.472 2.484
WLAN encryption modes: WEP40 WEP104 TKIP CCMP
WLAN authentication modes: open sharedkey wpa-psk wpa-eap
Module Alias: "pci:v000014E4d00004315sv0000103Csd00001508bc02sc80i00"
Driver Info #0:
Driver Status: ssb is active
Driver Activation Cmd: "modprobe ssb"
Config Status: cfg=no, avail=yes, need=no, active=unknown
Attached to: #25 (PCI bridge)
Alles anzeigen