Hallo,
die IP-Verbindung über eth0 wird bei mir erst erkannt, wenn ich das eth0 device down und wieder up setze:
Physische Verbindung an eth0 ist hergestellt, device eth0 ist up. Dennoch ist der state DOWN und NO-CARRIER wird gemeldet
Code
ip link show
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: eth0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast state DOWN mode DEFAULT group default qlen 1000
link/ether b0:25:aa:3e:1e:fe brd ff:ff:ff:ff:ff:ff
Nachdem das device down und wieder up gesetzt wird ist die Verbindung auch da:
Code
ip link show
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP mode DEFAULT group default qlen 1000
link/ether b0:25:aa:3e:1e:fe brd ff:ff:ff:ff:ff:ff
Da es prinzipiell funktioniert nehme ich an, dass Hardware & Treiber ok sind.
Wo kann konfiguriert werden, dass dauerhaft auf eine Verbindung geprüft wird?
Danke für die Hilfe.